oil pressure sensor location
 

My GTO came with the oil pressure line located here:

https://sphotos-b-ams.xx.fbcdn.net/h...86782364_n.jpg

The gauge seems to dance between 80 and 100 PSI (gauge could be broken).
I've got a mechanical autometer oil pressure I want to use (instead of the current one) with a copper line instead of the plastic one and was just wondering if that's a good location.

thanks,

there is a plug next to the distributor...that is the best most accurate location.
I have a guage running from both sites. seems the factory location at the oil filter sending unit reads a little higher than the hole next to dist...about 10 psi or so.

Mine picks up to the drivers side of the distributor hole in the block.

Have mine up by the distributor also.

Jim

On the filter housing is before the oil filter. Next to the dist is after the filter.

Anyone have a pic of the dist location handy? I would like to have a sender for my gauge, and a low oil pres. switch for a light/elec. choke.

George

gauge
 

I put the mechanical oil pressure connection at the dist hole. reads a few pounds lower than at oil
filter at warm idle.(had 17 at dist. location and 20 at oil filter when a swapped them).
- Use ONLY copper type line for a mechanical gauge!!!!!!

For piece of mind I put the factory type idiot light sender back in oil filter housing with stock
wiring. Car has idiot lights and like all them functional as well.

Gerry

That's where mine is, and it seems to work well. More importantly - what's with the Chevy Orange motor?

http://i299.photobucket.com/albums/m...120w20text.jpg

The plug in front of the date code. The square socket to remove it is 5/16".

I've encountered quite a few of those engines, one very recently. I've never actually talked to someone who painted it that way to find out what their logic in thinking was... Amusingly enough all have been Pontiac 350s.

Got it that way.. painting the engine is on my list, there's just too much other things to complete first..

and thanks for the replies everyone, learned another thing about Pontiac engines today

I know what you mean, there. My car actually came with the wrong oil filter mount. (It's not angled, so the instructions for changing the oil filter include "dent the filter with a hammer so it clears the frame.") I've got the correct part, but haven't got around to it yet.

hmm.. at least some previous owner didn't dent the frame to clear the oil filter.. :)

That square drive factory plug may be tight. I thought a gun had gone off when mine finally broke loose.

Thanks, Bill, I've got it now.

George

That is Pontiac Carousel red . LOL

I run off the filter adaptor on my GTO and off the block on my Grand Prix. Both have done fine but I prefer coming off of the top of the block, very accurate readings.

I have a question does anyone have a photo of the delivery location available? I want a gauge sender and an oil pressure switch for the light/electric choke. Pgsharp

What do you mean by “ delivery location”?

On the factory filter adapter the 1/8” pipe threaded hole where the idiot switch goes into is right off the pump output.

The hole that’s plugged off on the top of the block on the drivers side as in these previous photos here is on the output side of the oil filter.

If it’s the original square drive plug do not attempt to remove without soaking it with thread penetrant first and heating up - it is very easy to strip the square drive.