Help!Need dimensions for hood vents from 2000 or newer special edition GP
 

If anyone has a 2000 Daytona Grand Prix or a 2001-2002 special edition GP or a 2002 40th aniversary GP with the factory hood vents,I need the measurements for the 2 hood vents.I need from the side of the hood to the outside side of the vent and also from the back of the hood to the backside of the vent and from the front of the hood to the front side of the vent.I just got a set of the vents and the underhood rain drip pan and would like to install these on my hood in the stock factory location.If anyone can help with this it would be much appreciated.Thanks

just stumbled on your post....still need the dims??

Yes,I sure do and can you also give the dimensions between the vents besides the other dimensions listed at top?Thanks

sure can..........will do tomorrow! Shes out Christmas shopping. I have 02' 40th

front of hood to vents is 18 1/4
back of hood to vents is 8 7/8
between vents front is 4 1/8
between vents rear is 4 7/8
measured from edge of hood to inside edge of vent
front is 27" rear 27 1/8
I used inside because its more of a straight line than the outside curved edge
hood edge to vent is 19 1/8 at the rear

If a little confusing let me know I'll draw a pic, scan it & email to you.
PM your email. don't post

Thanks so much.Only dimension Im not sure is the 19 1/8 from hood edge to vent at the rear?Is that to the outside of the vent and the inside of vent from hood edge is the 27 at front and 27 1/8 at rear of vent.

I like the 2-tone maroon interior of the 40th.I actually installed a 2-tone light and dark grey 2000 Daytona interior in my 98 Daytona along with special edition light and dark grey door panels but still have the original seats stored away.Put a 2001 or 2002 SE white guage face also and a rear spoiler like yours.I never liked the flat stock rear spoiler.

The 27 1/8 is from side of hood to inside of vents. Should be 27 7/8's at the rear! The 19 1/8 from side edge of hood to out side rear corner of vent.