Another Mystery Parts ID Post
 

I'm sorting out my "trim shelf" ... don't think these belong to my 68 GTO.

1. Appears to be A pillar trim .. conv? 67 GTO?

https://forums.maxperformanceinc.com...6&d=1633599880



2. Door sill? Seat trim? Notice the curve in at the right side ... if it's door sill .. early 60's Corvette?

https://forums.maxperformanceinc.com...7&d=1633599887




3. Looks like A pillar trim ... like just the A pillar section of the piece on a 68 that is connected to the whole top piece. Again .. might be 67?

https://forums.maxperformanceinc.com...8&d=1633599892

Thanks!

I don't think the first two items have any home on a 68 A body even if it's a convertible.

The first piece goes on 68-72 A body convertibles. It goes on the outside of the A pillar. The second 2 pieces fit inside the A pillar of a 68-72 A body. , the leading edge of the front window seal up against it. It of course holds a soft seal. I have a 69 GTO convertible and a 72 442 so I have direct knowledge. I can't tell if its for a convertible or a hardtop.

android ... I thought the A pillar trim on a 68-72 A body HT was once piece from the bottom of the A pillar all the way back to the rear of the quarter window. At least it was that way on the two 68's I've had. The Convertible would have to have a separate A pillar piece because it couldn't extend back to the quarter window ... since the top moved.

That would make sense if the first part in the first photo is from a convertible .... the pair of other parts may be from the same convertible. Mystery is ... I think they guy that gave these parts to me had a 67.

I'm pretty sure the top piece goes on one side of the windshield of a convertible A body. I just sold a spare on e bay a few months ago.

1 drivers side 68-72 a body convert windshield pillar stainless.....
2 looks like chevy truck carpet trim in door jamb corner ??? NOT 68 69 gto
3 looks to be wing window 68 ?? side picture may help

just my .02

Agree the first piece looks like the outside chrome on an A pillar from a 69 A-body convertible (and possibly other years). Should be about 22' in length and range from 2 1/2 to 3" in width approximately.

Scott ... excellent ... I bet that is from my old 72 Chevy pickup which was painted green. In the garbage it goes :)