Base VE Table Help
 

Hello everyone,

I could use a little help from you folks that have experience, or perhaps engine dyno software.
I’m converting to EFI with an MS3, which is currently controlling the ignition. I think I’m ready to get the fuel side of things up and rolling, and hope maybe someone can give me some educated guesses on peak torque/rpm and peak HP/rpm, so I can figure out a starting place for the ve table.
Tuner studio has a table generator that seems to do pretty well, but it relies upon some information that I don’t have without a dyno. So, I hope maybe someone can help me with some numbers, based on my combo, either from real life experience with a similar set up, or because they’re a super computer.

462 with forged rods and L2359 pistons
Edelbrock D port heads with 1.65 shaft rockers
Butler/Comp Cams 8051 hydraulic roller
300/306 adv
248/254 @.050
114 LSA
.619/.639 lift with 1.65 rockers
Victor EFI intake

Flywheel numbers/guesses should get me in the ball park, and I can tune it out from there, but any help is much appreciated!
Thank you.

Travis