Black out filler panel
 

Hey all. What type of clip is needed for the screws for the Endura black out / filler panel that screws onto the core support.
Ty

None if I recall correctly. Just a big #14 x 7/8 sheetmetal hex head screw with washer
Should be in the assembly manual drawing, chapter 13,

Ok. Reason o ask is mine just push through at this point.
After looking at it it looked like a long J clip or such could snap into the support

There is no clip. They simply screw in. If the metal is worn out or stripped, they may not hold very tight. They do not need much torque to stay in place.