Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 97
Search took 0.01 seconds. Search: Posts Made By: Jake64
Forum: 64-65 GTO Tempest & LeMans TECH 08-10-2013, 12:32 AM
Replies: 11
Views: 388
Posted By Jake64
John, I also could find no confirmation in...

John,

I also could find no confirmation in my archives. As you stated in an earlier thread, there were connector issues, but no discussion on the rain gutter solution.

My initial thoughts on...
Forum: 64-65 GTO Tempest & LeMans TECH 07-28-2013, 05:22 PM
Replies: 5
Views: 269
Posted By Jake64
I have had success on show panels (maybe just...

I have had success on show panels (maybe just lucky) installing the emblems, which may be harder than removing existing. It's a two person job, and preferably one of the two should have narrow...
Forum: 64-65 GTO Tempest & LeMans TECH 07-25-2013, 11:18 PM
Replies: 8
Views: 440
Posted By Jake64
A tough illustration to view, at least with my...

A tough illustration to view, at least with my eyes. I'm taking a wild stab on this one.
The illustration shows the grill emblems for both the GTO (17) and the Tempest (40). Could 62 be the single...
Forum: 64-65 GTO Tempest & LeMans TECH 07-17-2013, 07:40 PM
Replies: 43
Views: 1,959
Posted By Jake64
Dick, I'm confused on a few of the points...

Dick,

I'm confused on a few of the points the judges felt were not corect.

The master cylinder should be natural, not black (assume they are looking for black phosphate). I had a master...
Forum: 64-65 GTO Tempest & LeMans TECH 07-05-2013, 10:17 PM
Replies: 112
Views: 6,896
Posted By Jake64
Sorry for the delay, the same camera operator...

Sorry for the delay, the same camera operator issues. I just hope one of the pictures of the clips comes out. As I stated, I doubt anyone will take note.

The yellow at the clip and below the...
Forum: 64-65 GTO Tempest & LeMans TECH 07-05-2013, 09:21 PM
Replies: 10
Views: 373
Posted By Jake64
Can't recall if I have ever seen a manual (3 or 4...

Can't recall if I have ever seen a manual (3 or 4 speed) block without the X, but it is possble (Maybe at one of the Columbus shows back in the '80's). And yes, the font is the same and applied as...
Forum: 64-65 GTO Tempest & LeMans TECH 07-05-2013, 12:56 AM
Replies: 14
Views: 502
Posted By Jake64
Dick: I was going to enter these pictures to...

Dick:

I was going to enter these pictures to the Petcock thread of a couple of weeks ago, but thought I would enter it here. Having issues with the camera (operator) and took many days and...
Forum: 64-65 GTO Tempest & LeMans TECH 07-01-2013, 05:21 PM
Replies: 112
Views: 6,896
Posted By Jake64
Bill, Are you sure it was the GTOAA and not...

Bill,
Are you sure it was the GTOAA and not POCI? I have never seen the GTOAA ask an owner for the removal of a wheel cover. Either way, looks like you got one tough judge. Something you said?!
Forum: 64-65 GTO Tempest & LeMans TECH 06-30-2013, 07:10 PM
Replies: 25
Views: 1,438
Posted By Jake64
Just got my camera back, and thought I'd attempt...

Just got my camera back, and thought I'd attempt a couple of pictures (still not a Nikon). I believe the only radiator cap available for 1964 was the cap pictured in post
13, first picture, and in...
Forum: 64-65 GTO Tempest & LeMans TECH 06-30-2013, 05:52 PM
Replies: 17
Views: 486
Posted By Jake64
My understanding is that the GTOAA Nationals will...

My understanding is that the GTOAA Nationals will be in Pittsburgh, Pa. I don't know the date.
I also understand that a 50th Anniversary show for the GTO will be held in Carlisle, Pa. I believe one...
Forum: 64-65 GTO Tempest & LeMans TECH 06-30-2013, 05:46 PM
Replies: 10
Views: 723
Posted By Jake64
I am not sure if this is what the amcguy said,...

I am not sure if this is what the amcguy said, but you might inquire and ask if the manufacturer would/could use your original cable and install the correct end on it. Might be pricey.
Forum: 64-65 GTO Tempest & LeMans TECH 06-29-2013, 06:04 PM
Replies: 3
Views: 188
Posted By Jake64
Tri Power Automotive Jon Markese ...

Tri Power Automotive

Jon Markese 847-816-3222
Libertyville, Illinois
www.TriPowerAutomotive.com
Forum: 64-65 GTO Tempest & LeMans TECH 06-28-2013, 06:04 PM
Replies: 19
Views: 537
Posted By Jake64
60sstuff: I may be confused, which my wife...

60sstuff:

I may be confused, which my wife claims is happening way too often of late, but I believe we are in agreement.
My reply was to B.R. who I believe was referencing the 2nd picture in...
Forum: 64-65 GTO Tempest & LeMans TECH 06-28-2013, 05:42 PM
Replies: 2
Views: 447
Posted By Jake64
Are you referring to the black nylon compartment...

Are you referring to the black nylon compartment straps that push into the upper channel of the core support? For 1964, (not familiar with 1965) I believe two vendors were used, one was Robins, part...
Forum: 64-65 GTO Tempest & LeMans TECH 06-27-2013, 06:16 PM
Replies: 19
Views: 537
Posted By Jake64
A couple of thoughts: I believe you are...

A couple of thoughts:

I believe you are correct that the plant correction/operation was behind the box, as for the most part, the three other plants that I have had an opportunity to review have...
Forum: 64-65 GTO Tempest & LeMans TECH 06-27-2013, 02:00 PM
Replies: 19
Views: 537
Posted By Jake64
I used one of m 187 paint chips and compared to a...

I used one of m 187 paint chips and compared to a 214. The match was dead-on. Evidently they did not change paint schemes between 1964 and 1965.
To update the formula I use, I utilize a 50:50 mix...
Forum: 64-65 GTO Tempest & LeMans TECH 06-25-2013, 02:54 PM
Replies: 112
Views: 6,896
Posted By Jake64
Bill, The photos by chrisp in Post 54 are...

Bill,

The photos by chrisp in Post 54 are correct, with the screws having a silver cadmium or natural finish.

However, the green fuel/brake line clips did not contain the rivets when they were...
Forum: 64-65 GTO Tempest & LeMans TECH 06-25-2013, 01:43 PM
Replies: 19
Views: 537
Posted By Jake64
I have used a 50:50 mix of the Rust Oleum gloss...

I have used a 50:50 mix of the Rust Oleum gloss black and dark brown on the '64 187. The same mix should also be ok for the '65 214. Be sure to mask off the bakelite top. The tops are often faded,...
Forum: 64-65 GTO Tempest & LeMans TECH 06-14-2013, 12:59 PM
Replies: 15
Views: 713
Posted By Jake64
1964 Petcock Here are a couple of more...

1964 Petcock

Here are a couple of more photos of radiator petcocks. The '64 has the ears of the wing facing forward towards the radiator. The wing is smooth. The brass fitting has the slot in its...
Forum: 64-65 GTO Tempest & LeMans TECH 06-11-2013, 01:54 PM
Replies: 37
Views: 1,419
Posted By Jake64
[QUOTE=John V.;4942454] On the LH Side...

[QUOTE=John V.;4942454]

On the LH Side dimple, I understood that my hole was punched out at a dimple, same as your Baltimore car. I may have misunderstood the description of your Fremont car,...
Forum: 64-65 GTO Tempest & LeMans TECH 06-07-2013, 03:33 PM
Replies: 2
Views: 431
Posted By Jake64
rohrt, Yes, the big cars, going back to at...

rohrt,

Yes, the big cars, going back to at least 1963, received 5 ground straps. These extra two ground straps were mounted to the upper A arm assemblies.

For 1964, the hose bracket was not...
Forum: 64-65 GTO Tempest & LeMans TECH 06-05-2013, 12:26 AM
Replies: 37
Views: 1,419
Posted By Jake64
Peter: I can make out the left side "V-8...

Peter:

I can make out the left side "V-8 Ground Strap" comment. However, I can't make out the final line on the right side. I can only make out (I think) "6 cylinder & V-8 Ground Strap with ????"....
Forum: 64-65 GTO Tempest & LeMans TECH 06-05-2013, 12:05 AM
Replies: 37
Views: 1,419
Posted By Jake64
"John, if you still have the fire wall insulating...

"John, if you still have the fire wall insulating pad, that will also help you determine where the stamped holes are to accept the pins. Somehow my comments have been entered into your post when I...
Forum: 64-65 GTO Tempest & LeMans TECH 06-04-2013, 05:38 PM
Replies: 37
Views: 1,419
Posted By Jake64
Using a tape measure, and trying not to scratch...

Using a tape measure, and trying not to scratch paint, came up with the following dimensions in terms of groundstrap securement placement into the fire wall. It may help if you are standing in front...
Forum: 64-65 GTO Tempest & LeMans TECH 06-02-2013, 11:27 PM
Replies: 12
Views: 751
Posted By Jake64
[QUOTE=John V.;4910374] ...

[QUOTE=John V.;4910374]

http://forums.maxperformanceinc.com/forums/showthread.php?t=486579



Note where it shows "PONT. 4310 D", same pic is in my '64 Shop Manual. Might have used same pic...
Showing results 1 to 25 of 97
Page 1 of 4 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 12:56 AM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017