Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.04 seconds. Search: Posts Made By: ID67goat
Forum: Pontiac - Street 05-24-2024, 05:00 PM
Replies: 9
Views: 160
Posted By ID67goat
I will have to check my old Edelbrocks to see how...

I will have to check my old Edelbrocks to see how they are setup. Do you have the 72 or 87cc heads? Also what lift are you running?
Forum: Pontiac - Street 05-22-2024, 09:59 PM
Replies: 11
Views: 455
Posted By ID67goat
Also what is the ignition timing?

Also what is the ignition timing?
Forum: EFI Tech 05-20-2024, 05:11 PM
Replies: 6
Views: 255
Posted By ID67goat
Sounds like the problem that I had with RF...

Sounds like the problem that I had with RF interference. What kind of plugs and plug wires are you using?

Once I swapped the plug wires I never saw the issue again.
Forum: Electrical Tech 05-11-2024, 08:21 PM
Replies: 5
Views: 182
Posted By ID67goat
Looks like your plug has the contact from the old...

Looks like your plug has the contact from the old headlight still stuck in it?
Forum: Pontiac - Race 04-10-2024, 07:29 PM
Replies: 23
Views: 1,306
Posted By ID67goat
Do you guys think they were able to save it? Did...

Do you guys think they were able to save it? Did not see an updated video so was guessing that it maybe didn’t work out…
Forum: 66-67 GTO Tempest & LeMans TECH 04-09-2024, 09:49 AM
Replies: 27
Views: 1,363
Posted By ID67goat
Yes, change the battery. I had an Optima battery...

Yes, change the battery. I had an Optima battery that seemed like it was OK, but sometimes after driving the car it would not crank over. I thought for sure it was something with the grounds,...
Forum: The Body Shop TECH 03-23-2024, 10:17 PM
Replies: 18
Views: 1,776
Posted By ID67goat
Website must be very old…did you see the labor...

Website must be very old…did you see the labor rates!.?
Forum: Suspension TECH 03-16-2024, 09:59 AM
Replies: 11
Views: 819
Posted By ID67goat
If you just swapped the box then a minor...

If you just swapped the box then a minor adjustment to the drag link shook easily center the wheel again. I wouldn’t touch the tie rods or you will affect the alignment.
Forum: 68-69 GTO Tempest & LeMans TECH 02-12-2024, 11:34 PM
Replies: 11
Views: 949
Posted By ID67goat
First thing I see is that the cable should go...

First thing I see is that the cable should go above the crossmember (near the floorboard) and not through it…at least that is how I remember it…
Forum: Pontiac - Street 01-31-2024, 09:38 PM
Replies: 22
Views: 1,120
Posted By ID67goat
Keith, great info. So I get the working...

Keith, great info.

So I get the working angles as seen from a “side elevation” of the vehicle, but what is the vibration influence if the angles are off from left or right from viewed from the top...
Forum: THE LOBBY 01-29-2024, 11:12 PM
Replies: 25
Views: 1,711
Posted By ID67goat
https://youtu.be/rh-OJkh1Ozg?si=l4KLjfMjvwaD3iUN ...

https://youtu.be/rh-OJkh1Ozg?si=l4KLjfMjvwaD3iUN

Here is a commercial for you…
Forum: THE LOBBY 01-24-2024, 08:03 PM
Replies: 54
Views: 4,804
Posted By ID67goat
https://youtu.be/Et1dj7YnXV4?si=hQQG1dve5v3yBUcy

https://youtu.be/Et1dj7YnXV4?si=hQQG1dve5v3yBUcy
Forum: Pontiac - Street 01-23-2024, 11:23 PM
Replies: 76
Views: 4,660
Posted By ID67goat
Did you pull inner springs or do anything special...

Did you pull inner springs or do anything special during break in? I will need to break in an SPC-8 cam soon….
Forum: Pontiac - Street 01-23-2024, 09:32 PM
Replies: 44
Views: 3,398
Posted By ID67goat
My balanced rotating assembly did not have any...

My balanced rotating assembly did not have any balancing info included and was found to be out 9 grams at the front and 12 grams at the rear.

Also to note, all the new “neutral balance” parts...
Forum: THE LOBBY 01-17-2024, 11:44 PM
Replies: 71
Views: 5,316
Posted By ID67goat
Sounds like you should have had either an agreed...

Sounds like you should have had either an agreed value policy or gap coverage.

I have never heard of an insurance company paying out KBB value and especially not auction prices….I think at best...
Forum: THE LOBBY 01-15-2024, 10:52 PM
Replies: 115
Views: 13,579
Posted By ID67goat
Do you know about how far your accessory and...

Do you know about how far your accessory and blower drive assemblies will stick out from the front face of the engine? Early GTO’s are a little limited on space between the radiator and engine….
...
Forum: THE LOBBY 01-15-2024, 09:33 PM
Replies: 11
Views: 771
Posted By ID67goat
Have used Malwarebytes in the past with good...

Have used Malwarebytes in the past with good results..
Forum: The Body Shop TECH 01-12-2024, 03:01 PM
Replies: 12
Views: 1,024
Posted By ID67goat
Is it off 1/2" front to back? Side to side? ...

Is it off 1/2" front to back? Side to side? Can't really tell by the picture.
Forum: THE LOBBY 01-10-2024, 01:39 PM
Replies: 120
Views: 13,070
Posted By ID67goat
The chief one cracks me up! Ripped skinny jeans...

The chief one cracks me up! Ripped skinny jeans and boots with frills? Don’t think I have seen that before….
Forum: Pontiac - Boost 01-07-2024, 12:24 AM
Replies: 120
Views: 54,087
Posted By ID67goat
R 70 Judge were you ever able to put these turbo...

R 70 Judge were you ever able to put these turbo manifolds to use?

I was curious to see if anyone has some feedback on how these fit in a stock chassis and if there is interference with...
Forum: 67-81 Firebird & TA Parts WANTED 01-03-2024, 11:24 PM
Replies: 10
Views: 724
Posted By ID67goat
Not to hijack, but does anyone know if the...

Not to hijack, but does anyone know if the reproduction quarters are any good?
Forum: Pontiac - Street 12-20-2023, 12:13 PM
Replies: 1
Views: 300
Posted By ID67goat
Butler Head Gasket CC's?

Anyone know what the Butler head gasket's CC at?

Part number: SPM-19374-2

Up to 4.191 bore and .045 crush, but since the hole is not round wasn't sure what these end up at..

If nobody,...
Forum: 66-67 GTO Tempest & LeMans TECH 12-13-2023, 09:05 AM
Replies: 6
Views: 3,041
Posted By ID67goat
While my Doug’s Headers were purchased many years...

While my Doug’s Headers were purchased many years ago and I don’t know if they changed anything on the ones that are sold now, I would say that the fitment is really good. Did not have to clearance...
Forum: Pontiac - Race 11-24-2023, 01:13 AM
Replies: 53
Views: 4,459
Posted By ID67goat
Long shot here…..but could the problem be from...

Long shot here…..but could the problem be from the coarse hone job holding more oil on the cylinder walls and then the rings are scraping the oil off and putting on top of the piston due to the gas...
Forum: THE LOBBY 11-03-2023, 08:19 PM
Replies: 5
Views: 483
Posted By ID67goat
Tecno BD4H is a Chinese phone model… More...

Tecno BD4H is a Chinese phone model…

More than likely this is a scammer!
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump

All times are GMT -4. The time now is 12:15 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017