Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: THEGTOCHISM
Forum: EFI Tech 05-01-2016, 09:00 PM
Replies: 1,209
Views: 91,599
Posted By THEGTOCHISM
efi

I saw something similar with fitech. and what it was was the intake. it was on a SBC but they changed from a dual plane to a single plain manifold and the torque numbers came up. The fuel injection...
Forum: The Body Shop TECH 04-28-2016, 08:25 PM
Replies: 2
Views: 564
Posted By THEGTOCHISM
Thank you for the information and reply. And...

Thank you for the information and reply. And thanks for taking the time to measure your hood for me. I will compare those numbers with my replacement hood.
Forum: The Body Shop TECH 04-28-2016, 05:31 PM
Replies: 2
Views: 564
Posted By THEGTOCHISM
gto hood dimensions, after market hood

are the after market gto hoods the same diameter across the front and rear as the original hoods. the reason i asked is i got a replacement 3 years ago for my 70 and to get clearance in the front, i...
Forum: 78 and Newer G-body Pontiac TECH 04-19-2016, 09:02 AM
Replies: 4
Views: 4,506
Posted By THEGTOCHISM
Question G BODY AC heater controls

working on the wife's 84 g-body. I replaces ac compressor ,dryer, orifice tube, flushed everything, new seals, pulled it down real low for 1 hr. added the r 135 change and it cooled great! for a...
Forum: Electrical Tech 03-13-2016, 05:18 PM
Replies: 8
Views: 232
Posted By THEGTOCHISM
i did a dash overlay on this car and was worried...

i did a dash overlay on this car and was worried that if i removed the dash there could be some fit/damage to during the process. I've had a few of these out years ago. But never tried to remove the...
Forum: Electrical Tech 03-09-2016, 03:16 PM
Replies: 8
Views: 232
Posted By THEGTOCHISM
printed circuit removal

can you replace the printed circuit on a 70 gto without removing the dash
Forum: Pontiac - Street 01-04-2016, 11:12 PM
Replies: 15
Views: 450
Posted By THEGTOCHISM
not a problem. All information is valuable. a...

not a problem. All information is valuable. a fella over at Monte Carlo sent me a drawing on how to connect it once the computer is by passed. Buts its only about 300-350 more rpm difference, And...
Forum: Pontiac - Street 01-04-2016, 10:35 AM
Replies: 15
Views: 450
Posted By THEGTOCHISM
350 lock up converter

Thanks overkill i have 245x60x15 tires in the rear so it should not be a problem. I may add a transmission cooler when i do the radiator swap
Forum: Pontiac - Street 01-03-2016, 09:58 PM
Replies: 15
Views: 450
Posted By THEGTOCHISM
switch

thanks for the information on the torque converter lock up on the th 350 transmission
Forum: Pontiac - Street 01-03-2016, 03:26 PM
Replies: 15
Views: 450
Posted By THEGTOCHISM
350 lock up converter plug

Thanks for the reply. I can't seem to find anything on a by pass for the 350 just the 200 and 700R transmissions. I cut/removed all the emission wires and it runs great after i added a new none...
Forum: Pontiac - Street 01-03-2016, 01:56 PM
Replies: 15
Views: 450
Posted By THEGTOCHISM
Question 350 TRANS LOCK UP CONVERTER WIRE NECESSARY?

I am working on a 84 Grand GP . I replaced the 305 with a 350 engine. And disconnected all emission controls . The wire to the torque converter is now disconnected. I see no difference in...
Forum: Heating & Cooling TECH 11-25-2015, 11:20 AM
Replies: 4
Views: 223
Posted By THEGTOCHISM
NO reason for it to be that way. A plate and a...

NO reason for it to be that way. A plate and a few bolts and it could come out from the firewall side. Just bad or no planning for repairs involved. The whole car is that way. I just wish the people...
Forum: Heating & Cooling TECH 11-24-2015, 11:11 PM
Replies: 4
Views: 223
Posted By THEGTOCHISM
never mind i did a back flush with water and air...

never mind i did a back flush with water and air and a cleaner and whatever was in there came out with a bang into the gallon container i was using. It now heats like crazy. I am so glad i didn't...
Forum: Heating & Cooling TECH 11-24-2015, 03:01 PM
Replies: 4
Views: 223
Posted By THEGTOCHISM
Question 95 Trans Am Heater core

I believe i need to replace the heater core on my 1995 firebird. Has any one done this or can offer instructions on how to remove the core? thanks
Forum: 1982-92 TA & FB TECH 11-16-2015, 12:07 AM
Replies: 3
Views: 486
Posted By THEGTOCHISM
I did that,i now got the temp to stabilize and...

I did that,i now got the temp to stabilize and now have heat. Pretty sure i finally got all the air out of the system. But i think it is possible there is a stop age in the heater core. I will try to...
Forum: 1982-92 TA & FB TECH 11-13-2015, 05:35 PM
Replies: 3
Views: 486
Posted By THEGTOCHISM
this thing is driving me crazy. i have the car...

this thing is driving me crazy. i have the car jacked up by the filler neck side. I have wasted over two gallons of anti freeze trying to bleed this thing. Now its trying to run hot i may have blown...
Forum: 1982-92 TA & FB TECH 11-13-2015, 12:12 PM
Replies: 3
Views: 486
Posted By THEGTOCHISM
Unhappy 1995 T/A Possible Heater Core Air Lock

I replaced the water pump. all front seals and opti spark distributor with wires and plugs and the ac compressor. about everything on the front was disconnected or removed. i installed a new...
Forum: 1982-92 TA & FB TECH 10-14-2015, 10:28 AM
Replies: 8
Views: 581
Posted By THEGTOCHISM
I got mine from Petris Enterprises it has a 5...

I got mine from Petris Enterprises it has a 5 year warranty and uses the same optics as the AC Delco dist. Plus it came with new vacuum lines and check valve. that alone sells for 75.00 on E bay. ...
Forum: Heating & Cooling TECH 09-30-2015, 10:34 PM
Replies: 1
Views: 232
Posted By THEGTOCHISM
never mind i found it in a 1999 firebird shop...

never mind i found it in a 1999 firebird shop manual
Forum: 1982-92 TA & FB TECH 09-30-2015, 07:31 PM
Replies: 8
Views: 581
Posted By THEGTOCHISM
purchased two "NEW" ac Delco opti sparks off e...

purchased two "NEW" ac Delco opti sparks off e rape. Both were rebuilt not new. One had it stamped on the box, unit, and paper work even. The other Was in a different box than the one in the listing....
Forum: Heating & Cooling TECH 09-29-2015, 12:19 PM
Replies: 1
Views: 232
Posted By THEGTOCHISM
AC Compressor oil question?

i am working on my 95 Firebird firehawk fixing oil leaks at the front seals. I have also it torn down pretty good with almost all the ac parts off. i did this because the ac compressor siezed up. Now...
Forum: Pontiac - Street 09-24-2015, 10:00 PM
Replies: 2
Views: 122
Posted By THEGTOCHISM
not a problem i found out the answer anyway....

not a problem i found out the answer anyway. front pulley is a neutral balance, no key way needed..
Forum: Pontiac - Street 09-24-2015, 09:56 PM
Replies: 9
Views: 237
Posted By THEGTOCHISM
thanks for the information and reply

thanks for the information and reply
Forum: Pontiac - Street 09-24-2015, 05:47 PM
Replies: 2
Views: 122
Posted By THEGTOCHISM
under drive pulley question

i am working on a 1995 LT 1 firebird. it had under drive pulley's on it when i got it. I am replacing all 3 oil seals in the front timing cover. When i removed the bottom crankshaft under drive...
Forum: Pontiac - Street 09-24-2015, 10:02 AM
Replies: 9
Views: 237
Posted By THEGTOCHISM
i think i could get everything including the...

i think i could get everything including the manifold and linkage for 45.00, I just don't remember seeing any 80's Firebirds with those on them.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 12:28 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017