Home Menu

Menu


          
PY Online Forums - Bringing the Pontiac Hobby Together > Search Forums > Search Results
Page 1 of 4 1 23 Last »
Showing results 1 to 25 of 90
Search took 0.01 seconds. Search: Posts Made By: aMaizedGoat
Forum: Electrical Tech 11-06-2010, 04:58 PM
Replies: 3
Views: 177
Posted By aMaizedGoat
Starting Problem

I have never had a problem starting my car until recently. When I turned the key a few weeks ago, the motor spun one time the the starter solenoid started clicking. I figured dead battery. After a...
Forum: The Body Shop TECH 03-08-2010, 02:03 PM
Replies: 0
Views: 121
Posted By aMaizedGoat
side roofrail weatherstrip Q - 69 GTO

Has anyone 'mitered' replacement weatherstrips where the A-pillar and roof meet?
My worn-out originals are mitered for the transition, but replacements are not. When test fitting, the bend creates...
Forum: The Body Shop TECH 02-26-2010, 03:36 PM
Replies: 2
Views: 221
Posted By aMaizedGoat
Body panel gaps

Does anyone know what the Hood, Deck Lid, and Door gaps should be on a 69 GTO?
Forum: Electrical Tech 11-09-2008, 02:25 AM
Replies: 9
Views: 393
Posted By aMaizedGoat
Umm, yeah..

my bad.
69 GTO HTP, A-37.. from the manuals
Does that help?
Thanks for bustin my b@lls!
:cool:
Forum: Heating & Cooling TECH 11-08-2008, 06:22 PM
Replies: 16
Views: 1,064
Posted By aMaizedGoat
My two-cents would be (1) timing, and (2) the...

My two-cents would be (1) timing, and (2) the rad.
The first time I lit my 462, my temp gauge went to 240 cuz I had a vacume leak at the carb base, the timing was off, and I had an air bubble in the...
Forum: Electrical Tech 11-08-2008, 04:23 PM
Replies: 9
Views: 393
Posted By aMaizedGoat
Lone black wire?

I cant figure out where this black wire with female connector goes?
The wire comes out of the Dash Harness main "wad" at the same point where the light & wiper switch connectors, and the white wire...
Forum: 68-69 GTO Tempest & LeMans TECH 10-25-2008, 03:31 PM
Replies: 8
Views: 328
Posted By aMaizedGoat
Update

So I pushed what looked to be the bar that drives the pump, it clicked into a new position, so now the motor runs without the pump being on.
Now the pump doesnt work at all?
Something is out of...
Forum: 68-69 GTO Tempest & LeMans TECH 10-25-2008, 03:12 PM
Replies: 8
Views: 328
Posted By aMaizedGoat
So I followed this post and got my wiper motor...

So I followed this post and got my wiper motor "unstuck", now the washer pump wont stop when I run the wipers?
Is the pump cam out of sync? Any ideas?
Forum: 68-69 GTO Tempest & LeMans TECH 10-25-2008, 11:47 AM
Replies: 11
Views: 254
Posted By aMaizedGoat
You got me? You are way deeper, or behind the...

You got me?
You are way deeper, or behind the panels than I ever went! Good luck.
Forum: 68-69 GTO Tempest & LeMans TECH 10-24-2008, 11:42 PM
Replies: 11
Views: 254
Posted By aMaizedGoat
help us help you..

Agreed: what's the year and model of the car you are refering too?
Forum: 68-69 GTO Tempest & LeMans TECH 10-24-2008, 06:04 PM
Replies: 79
Views: 4,610
Posted By aMaizedGoat
Keep it up!

I just passed the 9-year anniversary myself. Bought plates and tabs in Sept, been driving it around without any glass, interior, or hood. Looks like a rat-rod, but it's a kick in the pants!
Forum: 68-69 GTO Tempest & LeMans TECH 10-24-2008, 05:36 PM
Replies: 16
Views: 546
Posted By aMaizedGoat
Correct paint on bezels?

Can anyone post a picture of their non-hideaway bezels (headlight doors) for a 69 GTO?
Someone painted my bezel's black, so I'm trying to decipher what surface is chrome vs black.
This is a...
Forum: Suspension TECH 10-21-2008, 12:19 AM
Replies: 15
Views: 576
Posted By aMaizedGoat
I had my master cyl, rear cyl, and front calipers...

I had my master cyl, rear cyl, and front calipers rebuilt by a local brake guru. He suggested staying away from synthetic brake fluid, but suggested the ATE Super Blue or 200. You can switch...
Forum: The Body Shop TECH 10-20-2008, 11:52 PM
Replies: 4
Views: 220
Posted By aMaizedGoat
You shouldnt have to remove the fender. Try...

You shouldnt have to remove the fender. Try loosening the rocker bolts and a couple inner fender screws, then stick your arm through the gap.
Try putting the nut and socket on a magnet for a few...
Forum: Exhaust TECH 10-20-2008, 11:43 PM
Replies: 28
Views: 3,304
Posted By aMaizedGoat
I went for a 60-mile drive on Saturday and could...

I went for a 60-mile drive on Saturday and could have easily held a conversation with a passenger.
Oh BTW, I have no glass in the car, no hood, no carpet/headliner. Sounds... priceless!!
Forum: Suspension TECH 10-14-2008, 08:16 PM
Replies: 4
Views: 225
Posted By aMaizedGoat
I went through this. Make sure your lines are...

I went through this.
Make sure your lines are hitting the threads at 90 degrees. If your off, they wont seat.
As in the other post, dont torque them down all at once. They'll need a little...
Forum: Exhaust TECH 10-14-2008, 08:05 PM
Replies: 28
Views: 3,304
Posted By aMaizedGoat
Correction

I have the Goerlich XLerator long case mufflers. They give it a 7.0 noise rating.. not sure about that. I think the sound is great, but I dont drive from the rear bumper?!
A few people have...
Forum: Suspension TECH 10-07-2008, 06:21 PM
Replies: 2
Views: 264
Posted By aMaizedGoat
Did you bench bleed the master? I recall...

Did you bench bleed the master? I recall depressing the plunger as part of the bleeding process.
Did you get a short and long booster "rod" with the master cyl replacement?
Forum: Electrical Tech 10-07-2008, 05:44 PM
Replies: 5
Views: 374
Posted By aMaizedGoat
I am putting the car back together (took apart...

I am putting the car back together (took apart 9-yrs ago) and am using the original headlight switch. It's a little crunchy?
The front harness is new. Like I said, turn signals work, side markers...
Forum: Electrical Tech 10-05-2008, 06:53 PM
Replies: 5
Views: 374
Posted By aMaizedGoat
Headlight switch - root of all evil?

I got some bizzare happenings with my 69 GTO?
When I turn on the parking lamps, both turn signal indicators on instrument panel light up. I can rotate the dimmer a few times and it will go out, but...
Forum: Exhaust TECH 09-25-2008, 12:36 AM
Replies: 28
Views: 3,304
Posted By aMaizedGoat
I did the RARE Ram Air 2.5" manifolds with 2.5"...

I did the RARE Ram Air 2.5" manifolds with 2.5" system and X pipe, and XLellerator 18" mufflers.. freakin wicked sounding!
Quiet up front, but when you romp on it, you hear the roar out back!
Forum: Electrical Tech 09-22-2008, 07:40 PM
Replies: 13
Views: 737
Posted By aMaizedGoat
Max voltage out on externally regulated alt?

... "what voltage should I expect to see ? 13+ ?"

I installed a Voltage meter with warning lights. My light goes on at 14V?
Is the alt output higher than 14V? I'm hoping to increase the upper...
Forum: Pontiac - Street 09-11-2008, 11:58 PM
Replies: 41
Views: 4,502
Posted By aMaizedGoat
I used Mity Mounts on my 69. I chased the...

I used Mity Mounts on my 69. I chased the threads on the block prior to install, but the motor was out of the car.
When installing, the all three mounts (motor, trans) lined up perfectly.
If you...
Forum: The Body Shop TECH 09-11-2008, 11:46 PM
Replies: 8
Views: 439
Posted By aMaizedGoat
Call Pilkington Classics in Columbus, OH...

Call Pilkington Classics in Columbus, OH (800-848-1351). They sent me a front windsheild and rear glass and I had them etch the appropriate "Soft-Ray" logo with coding to match the originals.
Forum: The Body Shop TECH 09-11-2008, 11:40 PM
Replies: 3
Views: 595
Posted By aMaizedGoat
I bought 4 new ones from AMES for my 69, worked...

I bought 4 new ones from AMES for my 69, worked great.
Showing results 1 to 25 of 90
Page 1 of 4 1 23 Last »

 
Forum Jump

All times are GMT -4. The time now is 01:49 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Contact Us Home
Copyright © 2017