test
Showing results 1 to 22 of 22
Search took 2.50 seconds.
Search: Posts Made By: Bill Hanlon
Forum: Electrical Tech 08-31-2021, 02:19 PM
Replies: 14
Views: 570
Posted By Bill Hanlon
Even if they did have the appropriate shop...

Even if they did have the appropriate shop manual, I don't remember charts in the original shop manuals that had X ohms at Y degrees for various temperatures.
Forum: 64-65 GTO Tempest & LeMans TECH 08-08-2021, 07:06 PM
Replies: 10
Views: 938
Posted By Bill Hanlon
Cut it off three times and it is still too...

Cut it off three times and it is still too short???
Forum: Pontiac - Street 07-01-2021, 08:12 AM
Replies: 10
Views: 711
Posted By Bill Hanlon
Segal's law. "A man with a watch knows what time...

Segal's law. "A man with a watch knows what time it is. A man with two watches is never sure."
Forum: 61-66 Big Pontiac TECH 06-10-2021, 07:12 PM
Replies: 14
Views: 1,835
Posted By Bill Hanlon
1966 Chassis Parts Book lists 4.11:1 and 4.33:1...

1966 Chassis Parts Book lists 4.11:1 and 4.33:1 gearsets for 65-66 big Pontiacs. Same book lists a 4.10:1 for the 64 rear axle.

And then there are these from the Pontiac Master Parts Catalog...
Forum: Pontiac - Street 06-02-2021, 01:13 PM
Replies: 76
Views: 5,396
Posted By Bill Hanlon
Except for Ford Model A rear axles with a key to...

Except for Ford Model A rear axles with a key to attach the axle to the hub. ;)
Forum: Pontiac - Street 05-04-2021, 12:32 AM
Replies: 9
Views: 528
Posted By Bill Hanlon
Note that the MPC calls out your 9773216 seal AND...

Note that the MPC calls out your 9773216 seal AND another, different size seal 9784286 also used on some 64-65 Tempests (and GTOs) as well as full size 66 Pontiacs. That crosses to SKF 19273. Specs...
Forum: Pontiac - Street 05-03-2021, 10:05 PM
Replies: 9
Views: 528
Posted By Bill Hanlon
... and here is the page from the 1966 MPC...

... and here is the page from the 1966 MPC stating that seal # 9773216 is 1 5/8" ID and 2 21/32" OD.
Forum: Pontiac - Street 01-27-2021, 12:54 PM
Replies: 22
Views: 1,191
Posted By Bill Hanlon
The HEI will be pulling little current with the...

The HEI will be pulling little current with the switch on and the engine not running. In that case you may read as high as 12V at the HEI power connector, even if the supply is through a stock...
Forum: Pontiac - Street 01-27-2021, 11:05 AM
Replies: 22
Views: 1,191
Posted By Bill Hanlon
Did you check it with the engine running?

Did you check it with the engine running?
Forum: 60 & Older Pontiac TECH 01-25-2021, 02:43 AM
Replies: 12
Views: 1,246
Posted By Bill Hanlon
I put a Delco 10SI type alternator on the 347...

I put a Delco 10SI type alternator on the 347 Pontiac engine that came in my '57 GMC truck. It is a 3 wire. Got it from Either O'Reilly's or AutoZone, cant remember which. Generic number is 7127. ...
Forum: Pontiac - Street 12-28-2020, 10:15 PM
Replies: 57
Views: 2,233
Posted By Bill Hanlon
If you are going to leave it overnight, throw the...

If you are going to leave it overnight, throw the keys in the drain pan. ;)
Forum: Electrical Tech 12-16-2020, 07:49 PM
Replies: 12
Views: 1,922
Posted By Bill Hanlon
To determine "not sure if it is too much or not...

To determine "not sure if it is too much or not enough" check voltage at the - side of the coil with the points closed, the key on, but the engine not running. Record the voltage. Now open the...
Forum: Pontiac - Street 12-16-2020, 01:01 PM
Replies: 41
Views: 1,593
Posted By Bill Hanlon
Not the same ignition or vehicle, but I had a...

Not the same ignition or vehicle, but I had a friend make a mounting plate for my '52 GMC six distributor. I put a mid-70's Chrysler slant six pickup and reluctor wheel in the distributor and hid a...
Forum: Pontiac - Street 11-29-2020, 02:01 PM
Replies: 31
Views: 1,295
Posted By Bill Hanlon
320 amps for 10 feet at 194 degrees F max air...

320 amps for 10 feet at 194 degrees F max air temp (depending on insulation type on the wire) would require 3/0 (000) wire all the way from the alternator to the battery. Same for ground. That...
Forum: Pontiac - Street 09-19-2020, 10:34 PM
Replies: 17
Views: 1,738
Posted By Bill Hanlon
What centers the tool on the crankshaft?

What centers the tool on the crankshaft?
Forum: 64-65 GTO Tempest & LeMans TECH 09-16-2020, 04:37 PM
Replies: 12
Views: 1,040
Posted By Bill Hanlon
Sway bars should have little to no effect on ride...

Sway bars should have little to no effect on ride quality while driving in a straight line.
Forum: Pontiac - Street 01-02-2020, 10:31 PM
Replies: 87
Views: 7,810
Posted By Bill Hanlon
Having that spare ready is what is keeping the...

Having that spare ready is what is keeping the Pertronix running. ;)
Forum: Pontiac - Street 12-16-2019, 05:16 PM
Replies: 10
Views: 2,136
Posted By Bill Hanlon
Before you go to the trouble, make sure your...

Before you go to the trouble, make sure your error is linear. Use a GPS type app and a helper to operate your phone. Let's say the error is 70 indicated (on the speedometer) is 60 actual (on the...
Forum: 60 & Older Pontiac TECH 01-20-2014, 02:40 PM
Replies: 7
Views: 264
Posted By Bill Hanlon
Is it using brake fluid? If not, it is not...

Is it using brake fluid? If not, it is not leaking into the booster. Fluid MAY just be leaking past the primary cup in the master cylinder and returning to the reservoir.
Forum: 61-66 Big Pontiac TECH 01-07-2014, 04:59 AM
Replies: 21
Views: 526
Posted By Bill Hanlon
Funny that all the other items had cents (ie....

Funny that all the other items had cents (ie. 43.00 for tinted glass) shown on the invoice even when it was an even dollar amount while the "trailer provisions" was listed as 990 (not 990.00) with no...
Forum: 61-66 Big Pontiac TECH 12-10-2013, 08:21 PM
Replies: 7
Views: 405
Posted By Bill Hanlon
Rock Auto calls for SKF 19310 for '65 and SKF...

Rock Auto calls for SKF 19310 for '65 and SKF 19273 for '66. They are definitely different. Here are the specs:

http://www.rockauto.com/catalog/moreinfo.php?pk=1842228&cc=1350234...
Forum: 60 & Older Pontiac TECH 10-27-2013, 10:40 PM
Replies: 6
Views: 286
Posted By Bill Hanlon
Not knowing what year your TH400 is, I picked '68...

Not knowing what year your TH400 is, I picked '68 Bonneville and looked up the seal on Rock Auto. They list two parts. One is an SKF 15041 which has a shaft size (ID) of 1.5" and a OD of 2.381" ...
Showing results 1 to 22 of 22

 
Forum Jump

All times are GMT -4. The time now is 03:01 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 

Cold Case Radiators

Cold Case Radiators is a Max Performance company that produces high end aluminum performance radiators at a price point that won't break the bank. Polished and stamped tanks. 2 rows of 1" tubes. Lifetime Warranty.

GTOG8TA.com

GTOG8TA.com is a Max Performance company that manufacturers parts for the 04-06 GTO, 08-09 G8, and 93-02 Firebird/Trans Am platforms.

Copyright © 2017