Showing results 1 to 25 of 58
Search took 0.01 seconds.
Search: Posts Made By: jray1
Forum: 2008-09 G8 Parts FOR SALE/WANTED 08-16-2015, 06:24 PM
Replies: 0
Views: 16,141
Posted By jray1
G8 parts for sale

I have a complete jack kit for the G8 I had shipped from Australia. I also have 5 stock G8 GT 18" wheels with tires, 2 of which are nearly new. 4 of them have the tpms sensors and all have the...
Forum: 61-77 GTO, Tempest & LeMans Parts For SALE 07-15-2013, 08:04 PM
Replies: 5
Views: 327
Posted By jray1
Nobody's in need of a really good Muncie?

Nobody's in need of a really good Muncie?
Forum: 61-77 GTO, Tempest & LeMans Parts For SALE 07-13-2013, 08:56 PM
Replies: 5
Views: 327
Posted By jray1
Forgot about the price thing. $800 o.b.o. plus...

Forgot about the price thing. $800 o.b.o. plus shipping or free local pickup. Zip is 35986.
Forum: 61-77 GTO, Tempest & LeMans Parts For SALE 07-13-2013, 06:18 PM
Replies: 5
Views: 327
Posted By jray1
any interest in a fresh rebuilt muncie?

I have a 68 coded, was told by the Pontiac man "68 gto" Muncie freshly rebuilt new bearings and seals. All gears were inspected and no chips or issues seen. Ran it for 950 miles before swapping to an...
Forum: Heating & Cooling TECH 11-09-2012, 07:46 PM
Replies: 103
Views: 4,208
Posted By jray1
My car seemed to run just fine plenty of power...

My car seemed to run just fine plenty of power started good. After breaking 2 rocker studs and bending a few pushrods up like pretzels then talking with Jim at butler performance I went with the 7/16...
Forum: Heating & Cooling TECH 11-08-2012, 09:12 PM
Replies: 103
Views: 4,208
Posted By jray1
Finally getting the 400 cooling the way it is...

Finally getting the 400 cooling the way it is supposed to. Went with the champion 3 row radiator and took a serious look at my rocker adjustment which was way to tight. After a total readjustment of...
Forum: Heating & Cooling TECH 10-12-2012, 01:16 PM
Replies: 103
Views: 4,208
Posted By jray1
Any thoughts on down flow verses cross flow?

Any thoughts on down flow verses cross flow?
Forum: Heating & Cooling TECH 10-09-2012, 12:19 PM
Replies: 103
Views: 4,208
Posted By jray1
Took a 40 mile drive Sunday evening with temps...

Took a 40 mile drive Sunday evening with temps 48-50 degrees I think and I sat at 190-195 the whole time. This was with a 3 mile pull up the mountain I live on as well. If it was 90+ degrees outside...
Forum: Heating & Cooling TECH 10-03-2012, 10:23 AM
Replies: 103
Views: 4,208
Posted By jray1
Intake temps are about half of what they were On...

Intake temps are about half of what they were On the heat crossover with the blockoffs.
Forum: Heating & Cooling TECH 10-03-2012, 10:21 AM
Replies: 103
Views: 4,208
Posted By jray1
Ran good this morning, took a lot longer to warm...

Ran good this morning, took a lot longer to warm up but it did finally get to 190. It seems that is the best I am going to get. I did however have to back down the timing again after adding a little....
Forum: Heating & Cooling TECH 10-02-2012, 01:33 PM
Replies: 103
Views: 4,208
Posted By jray1
Heat crossovers are blocked, everything's back...

Heat crossovers are blocked, everything's back together and just idling in the shop its working perfect. Warmed up fan came on cooled for almost a minute and the temp dropped fan turned off. Now I...
Forum: Heating & Cooling TECH 09-30-2012, 08:33 PM
Replies: 103
Views: 4,208
Posted By jray1
Made me laugh.:D

Made me laugh.:D
Forum: Heating & Cooling TECH 09-29-2012, 02:02 PM
Replies: 103
Views: 4,208
Posted By jray1
Ok. I was just wondering if I blocked the...

Ok. I was just wondering if I blocked the crossover off I might help the temps.
Forum: Heating & Cooling TECH 09-29-2012, 05:00 AM
Replies: 103
Views: 4,208
Posted By jray1
Where could I have an air pocket if I have the...

Where could I have an air pocket if I have the thermostat gutted so its just a slight restriction and no holding the water back?
Forum: Heating & Cooling TECH 09-29-2012, 04:56 AM
Replies: 103
Views: 4,208
Posted By jray1
Not the water crossover. I was talking about the...

Not the water crossover. I was talking about the heat crossover in the center of the intake that runs under the carb it was reading 270.
Forum: Heating & Cooling TECH 09-28-2012, 10:42 PM
Replies: 103
Views: 4,208
Posted By jray1
Well at least you seem to have a definite issue...

Well at least you seem to have a definite issue solver. Wish I could say the same.
Forum: Heating & Cooling TECH 09-28-2012, 01:12 PM
Replies: 103
Views: 4,208
Posted By jray1
Well 195-205 is the best I have been able to...

Well 195-205 is the best I have been able to achieve. Running down the road or sitting idling it stays at that temp. Even after going to the 6.5 waterpump pulley that's the best I can get. I shot...
Forum: Heating & Cooling TECH 09-25-2012, 11:03 PM
Replies: 103
Views: 4,208
Posted By jray1
Believe me I know the feeling.:D

Believe me I know the feeling.:D
Forum: Heating & Cooling TECH 09-25-2012, 09:35 PM
Replies: 103
Views: 4,208
Posted By jray1
I am very surprised by that as well.:eek:

I am very surprised by that as well.:eek:
Forum: Heating & Cooling TECH 09-25-2012, 06:55 PM
Replies: 103
Views: 4,208
Posted By jray1
I would call Butler performance and ask them the...

I would call Butler performance and ask them the best option.
Forum: Heating & Cooling TECH 09-24-2012, 11:29 PM
Replies: 6
Views: 263
Posted By jray1
Just put a vintage air in my 64 and as far as...

Just put a vintage air in my 64 and as far as installation it was fairly straight forward and step by step. It wasn't hard to do but yes crawling around under the dash is a bear. Their sure fit kit...
Forum: Heating & Cooling TECH 09-24-2012, 07:53 PM
Replies: 103
Views: 4,208
Posted By jray1
yes it went back to crossover. There are 2 ports...

yes it went back to crossover. There are 2 ports onthe water crossover so the temp sensor can go on either side. I just t'd the heater core line from the back of the head and run another hose to the...
Forum: Heating & Cooling TECH 09-23-2012, 09:39 PM
Replies: 103
Views: 4,208
Posted By jray1
I guess being a custom set up makes it even...

I guess being a custom set up makes it even harder to diagnose the problems. I am running an electric puller fan with a custom shroud (sealed to the core) the radiator seems to be doing its job, as...
Forum: Heating & Cooling TECH 09-23-2012, 05:38 PM
Replies: 103
Views: 4,208
Posted By jray1
Right now I have the hose out the back passenger...

Right now I have the hose out the back passenger head that goes to the heater core t'd So it goes from the back of the head to the passenger side of the intake. With a vintage air system there is an...
Forum: Heating & Cooling TECH 09-23-2012, 11:36 AM
Replies: 103
Views: 4,208
Posted By jray1
Sorry to hear that, after getting some more time...

Sorry to hear that, after getting some more time to check mine yesterday I am not totally out of the woods either. Mine is running way cooler now it takes a long time for the temp to get up but it...
Showing results 1 to 25 of 58

 
Forum Jump

All times are GMT -4. The time now is 08:44 PM.

 

About Us

The PY Online Forums is the largest online gathering of Pontiac enthusiasts anywhere in the world. Founded in 1991, it was also the first online forum for people to gather and talk about their Pontiacs. Since then, it has become the mecca of Pontiac technical data and knowledge that no other place can surpass.

 




Copyright © 2017