[simsb52]

First, I would like to thank Jeff Mahon for letting me test with his engine. Couldn't have done it with out him. Here is the engine specs.
Super duty block bored .040 over
Ross pistons to match
Super duty heads #16 ported
Total seal gapless rings
stock crank offset ground to 4.250 stroke
Eagle Rods
super comp headers with 2" pri. 3" collectors
Crane Hyd.Roller cam int. [email protected] exh. [email protected] 113 lsa
Crane HR lifters
Norris 1.6 roller rockers
1- 100% perfect Cliff Ruggles Q-jet carb IT RAN PERFECT!!!
Performer RPM intake

Thanks to all for the patience. It seemed to take forever to get to the dyno

Also I would like to thank Roger Williams of Williams Precision Engines. 765-525-4825

Thanks...Scott