Thanks Bob,
I was planing on taking them out to measure/ count threads. Your reply specificly addresses bolts, do studs fall into the same catagory as bolts in your machinist handbook? All I have is an old NAVAIR 1-1A-8 structural hardware manual, it does not address stud tread engagement.
__________________
1969 Firebird, Tx3-455/468 machined by CVMS
E-heads by Dave Wilcox/Comp Cams 300B-6 flat solid
850DP on E-85 by Eric Niefert/T2 1" plastic spacer
T-400/PTC 4000/390's/30x9 Hoosier radial slicks,#3400
1.38 60' 6.32 @ 108 MPH at Northeast Dragway NC 5/23/15 (9th pass on new engine)
https://m.youtube.com/watch?v=ePCu2v...ature=youtu.be
1.37 60' 6.26 @ 109 half track, 9.86 @ 136 1/4 mile, #3350 11/26/16 at Richmond Dragway (125th pass on new engine)
|