not sure what part you replaced. Was it the ing. switch that attaches to the lower part of the sterring column. If so there is a little bit of an adjustment in them. Use a test light at the starter sol. to make sure if you have power on the small term. when your in the cranking mode. If you do then it is in the starter if you dont then start looking at the switch if the net. saftey is ok as described in the other post. if that is all ok then it could be in the sterring column with the rod that moves the ing. switch on the lower part of the column. it can get bent. and if its a tilt column there is a piece that breaks pretty easy.
Wade
|