Here you go:
This information was take from an article entitled “GM Chassis Detail” that appeared in the May 2000 issue of Musclecar Review. The chassis used for reference in the article was a 70 RA IV Judge owned by Dan Jensen (Is he a forum member?).
Frame: Black (PPG DP 90 Epoxy)
Front-Brake Assembly
Calipers: Gray Phosphate
Caliper attaching bolts: Silver Zinc
Caliper mounting brackets: Zinc Dichromate
Brake rotors: Detail Gray
Dust Shield: Silver Zinc
All crimp nuts Silver Zinc
Brake-line clips (Gm PN 343464): Factory Blue
Brake junction block: Spray Gray
Suspension
Spindles: Detail Gray
Urethane sway-bar bushings: Detail Gray
Bolted upper ball joint: Detail Gray
Upper suspension: Gray Phosphate plating
Coil springs: Gray or Black paint
Shock-absorber hardware: Silver Zinc
Wheel-bearing dust cover: Silver Zinc
Front/rear sway bars: Spray Gray
Steering
Steering box: Gray Phosphate
Pitman arm: Detail Gray
Idler arm: Detail Gray
Idler-arm stem: Spray Gray
Steering shaft: Detail Gray
Steering arm: Detail Gray
Tie-rod ends: Detail Gray
Tie-rod adjusting sleeve: Black zinc
Center link: Spray Gray
Axle
Center section: Spray Gray
Shocks: Special-mix Gray lacquer
Axle tubes: Detail Gray
Pinion yoke: Gray phosphate
Motor mounts: Gray phosphate
Paints
Detail Gray: Part No: 10036Z Eastwood Co.
Spray Gray: Part No: 10032Z Eastwood Co.
PPG Epoxy Primer: Part No: DP 40
PPG Primer/Surfacer: Part No: K36
PPG Epoxy: Part No: DP 90
Black: DP 90
|