A while back I ordered a set of cheap headers from Summit for the 67-69 firebird because I heard these were similar to the 68 GP's. After pounding on the driver's side header for hours I realized it wasn't going to work. I recently regained interest in this project and got the passenger side to fit with minimal poundage. The drivers side got all the tubes cut off about an inch from the flange. I'm ordering three j-tubes from Summit tonight to try and weld up a header for the driver's side. Do you guys have any suggestions. I know I have to make sure I can get the bolts on and off. Anything else I need to know? Thanks, Jimmy.
__________________
Sometimes I think about how much more money I'd have if my car got better mileage, but when I hammer the gas and I smell that tire smoke........I remember that I also spend a lot of money on tires.
|