Hi,
I have a 69 WG engine out of a big car. I believe the car was a 69 Ventura.
The WG is a manual tranny coded engine. It is a 360HP 428, but it has #62 heads. I confirmed through some of my documentation that the #62 heads are correct. Without pulling the pan, I'm trying to determine if it is also a 4-bolt main. According to one source, it should have 4-bolt main caps. Another source isn't specific about whether it should have 2-bolt or 4-bolt bottom end. I know the 360 HP 428s are 2-bolt main bottom ends with #46 small valve heads.
Does anybody have any documentation that would indicate if this is a 4-bolt or 2-bolt bottom end?
MIke
|