If you guys look carefully at the chart, you will see that the scales for the HP and TQ are different. This causes the lines to intersect at a point other then 5252 RPM. If you were to plot the curves on the same scale then they would indeed cross at 5252 RPM.
Here is a video of a few dyno runs. I seem to have a problem with my video camera thats why the audio cuts out sometimes.
Dyno video
The only thing that was done by Detroit Speed and Engineering was the dash insert, wiring, and vintage air install. They had nothing to do with any part of the driveline.
Andrew
Project GatTagO
[This message was edited by Project Gattago on March 15, 2003 at 08:49 PM.]