Okay .. I am geting ready to FINALLY put the exhaust system in and I have run into a slight problem.
I have the Torque Tech 3 1/2" collector, 3 1/2 x 3" Dr. Gas 'X' pipe, 3" pipes and Dynomax (Large) mufflers.
My problem is WHERE to locate the cross over. When I use the pipes as supplied by Torque Tech the cross over hits my drive shaft safety loop. Since I have to be wthin 6" of the U joint I dont have a lot of play.
Any suggestions? This can't possibly be a new problem!!!
|