My 2000 montana has a bad front wheel bearing so I replaced it and just took it for a drive and after about 10 miles I started to hear a clunking in the front end.Something loosend up I will check tomorrow too see what but right now I want to see if I did anything wrong.There are 3 13mm bolts that hold the hub/bearing assembly on I torque them to 65 ftlbs with no thread locker and torqued the big driveshaft nut to 175 ftlbs also no thread locker and I reused all the bolts, was this the right way or should I have torqued differently or used some sort of locker or do you have to replace the big nut and small bolts everytime?any help will be much appreciated thanks.
|