Have installed the Repro '67 RA Exhaust manifolds on my '66 GTO. Also installed four wheel disks, so I have the proportioning valve on the left hand side of the frame, just aft of the front cross member. Installed Fine Lines brake lines. Noted when I dropped the engine in the left exhaust manifold was awfully close to the brake line going over to the right brake (about 3/16" away). Took the rolling chassis to Tiger Run (NW Regional GTO show) this week end. Got a lot of good compliments, but several people told me that on the '67 with the RA manifiold, the brake line for the right side went over the top of the cross member and then across to the right side, passing in front of the cross member.
I plan on using silicon brake fluid. Do I need to be concerned about the heat in the line?If so would a stainless heat shield be enough to help?If not, does anybody have a picture of the '767 lines so I can make new ones?
Ed
|