Marty,
Thanks for the glue tip.
I was hoping to find a tar-based glue (the old Ortho pruning sealer formula
) instead of a Rubber Cement based glue...because you are correct about the Tolulene solvent boiling through the vinyl-impregnated fabric top.
For those that might think so...3M spray adhesive is out...the same solvent will bleed right through & spot the top, and it doesn't retain it's stickiness in the weather.
Heck, hot candlewax would be better than a solvent based glue...Iron-out the bulges..
HIS
"tbdET/1xxMPH/1.xx 60foot/28"/3.54:1/10"/469 #48/Flat HYD/DualQ-Jets/Offyl/3xx0Lbs
11.00/123MPH/1.50 60foot/29.5"/4.10:1/10"/469 #48/FlatHYD/DualQuad/Wenzler/3250Lbs
12.00/112MPH/1.61 60foot/26"/3.31:1/10"/469 #48/FlatHYD/Q-Jet/Torker/3650Lbs
12.70/103MPH/1.71 60foot/28"/4.10:1/12"/469 #48/FlatHYD/Q-Jet/Torker/3950Lbs"