ok found the setup a bit back, did you say you would be running a 2.56 gear? I'm thinking you may need a little more gear in there.
Are you still running the 3800 stall converter?
I use the napa (Echlin) rebuild kit part # 2-5419. Where did you get your kits from. Old Man Taylor has always advised me to run the pump shot on the inside hole for the best shot. Are your pump rods the correct length? Are you getting full range of motion of the pump?
A few more things to think about...
Kev
------------------
Kevin Swaney
Gold '66 GTO powered by a 389 with Trips
with 4 spd 13.042 @ 106.64 mph
with TH350 12.643 @ 104.48 mph
__________________
Kevin Swaney
Tin Indian Performance Rear Engine Dragster 7.66 @ 172 mph 494 with KRE High Port Heads
www.tinindianperformance.com
330-699-1358
|