finally had a chance to get this system buttoned up, working from the rear and progressing forward.
The hardest part was getting everything clearanced around the muffler and "holding" the system prior to welding. The lead pipes were shortend about 8" on the tail end and the X-over pipes was shortened about 3" on the tail end.
I used the supplied "rod" hangers and slipped them through the factory grommets then welded the opposing ends to the upper pipes at the muffler to support the system. I will be removing the clamps for a cleaner look.
Here are some pics.
__________________
Home of WFO Hyperformance Shaker induction.
|