Pic of my new intake setup
Just got my engine back together, again.
I decided to give the "Gutsram" a try.
This intake needed lots of attention to make it fit.
I also had a custom top made, the carbs sit at an angle so that the throttle bores line up with the port runners.
This top is about half the weight of the stock cast top as it was cnc'd out of a piece of 6061 billet aluminium.
If there is anyone that has used one of these that has any tuning information to share it would be appreciated (including the N2O fogger).
I was also able to install my new timing chain set, with the torrington thrust bearing, that I got from Scott Simms of "Simms Performance".
I must say that this is a quality piece and the directions that are supplied with it are clear and precise. Thanks Scott!
Hopefully I will get the time to get this setup dailed in soon.
Todd
|