[wlpsyp]

Thanks for the info guys. I do not like the idea at all of adding water into the equation. Water and bare metal to me just does not make sense as it would start to flash rust right away I would think.

I really dont like the idea of spraying it down with phosphoric either as it says to keep the area wet for a minimum of 10 minutes to help remove microscopic rust then clean off with water. If we took out steps 2, 3, 4 and 5 would we be okay? My only concern would be that we did not get all the microscopic rust out, will that be a concern of spraying over some rust? Will the rust spread over time?

I will have to investigate Hammered's idea of urethane as I never thought of that and do not know if there will be any compatibility issues. I like the idea though, just dont know how much time I have between the DP primer and then spraying urethane as I do not want to have to "scuff" the paint if it is sitting to long and it is going to take a good day just to seam seal everything. I would like to be able to get this done in two days once step one is complete which will be today.

Thanks for the advice guys. I just dont want to screw up Amanda's car because I sprayed something wrong or in the wrong order.

Bill