Thread: motor blown on break-in, machinist's fault
View Single Post
  #1  
Old 06-21-2006, 07:55 AM
Half-Inch Stud's Avatar
Half-Inch Stud Half-Inch Stud is offline
Ultimate Warrior
  
Join Date: Jul 2000
Location: BlueBell, PA or AL U.S.A.
Posts: 18,902
Default
Thus far the Press-Fit process is most suspect huh.

Door #1: Induction heated vs

Door#2: Draw-Bar or HYD arbor...leads to windowing the block.

Curious if antifreeze got into the oil.

Reply With QuoteReply With Quote