Hello Esahlin,
I was expecting some fit issues witht the outer wheel well, you did give me the heads up on them - Thanks. We have made a patch to the lip of the wheel well and are gonna try to make it work - if not I may need to order a new one.
I got some prep work done on the rear panel bracing, I used a thin wire wheel to get in good where the weatherstipping will sit - this worked great.
Sanded it and 3M wheeled a few areas. I cleaned the bare metal with paint prep and was ready to brush on Eastwoods rust encapsulator as my first coat, this can be used as a primer coat too but when I Prime other areas this may get a coat of Epoxy Primer, I then will apply a top coat of Por 15.
I went over the areas better on the side bracing, removed more surface rust then applied Rust Mort on all the bare metal. Fusor Panel Adhesive will be used in the drip rail, where the quarter sits on the rocker panel and the vertical lip of the door jam - the rust mort in these locations is temporary and will be sanded off completely when Im ready to Glue these locaions. The panel adhesive is applied (bare metal to bare metal). I did use the Picklex 20 on the sail panel area where the factory seam is located because I will be welding there.
|