[67'7F6'Bird]

Esahlin -I am gonna look into the USA made Inner Tail Panel - Thanks! Can you post pictures of your inner panel also to show the gap with the original GM inner Panel. I think my original inner panel fit tight below the license plate - I didn't take any pictures of it though.

We have made our best 4 week effort on panel alignment, here are the photos. We have used screws on the drivers quarter panel, rear valance panel, inner tail panel and outer Tail panel. All these were mated to the original passenger side quarter panel.

Some minor trimming and grinding was needed is some areas, mostly where the quarter meets the tail panel and the rear valance panel.