I'll see if i can get a pic of my inner to outer tailpanel center gap. My inner is original but it has been bent to straighten it since I found that the car had been hit in the rear. I might not have the best example for you......but I did end up with a gap very similar to yours there in the center of the panels.
Your other panel alignment/fit look good to me. The side gaps between the trunk-to-rear-window-panel and the quarters never got perfectly even from side to side for me. I dont know if that was the fault of the panel or not. I ended up using a Fusor 2K (two part) self leveling seam sealer for those two gaps to match the factory look.....but I still thought they looked a little uneven so I gave up and removed the sealer and welded the side gaps. Then filled the weld area with fiberglass filler. I smoothed the filler so no gap can be seen on my car but some guys grind a perfect gap into the filler (with a cut-off tool etc) to get that factory seam indentation look. I mention that as an option if you find your not satisfied with the gaps there after much trial fitting.
|