[67'7F6'Bird]

I did spend most of the day sanding the top of the original trunk lid. 80 Grit paper and the 3M wheel - very slow speed for the edge. I applied the Picklex 20 after I got it to bare metal, which if you look close there was still some black spots(rust) I couldn't remove, I hope the Picklex will do the trick on this piece. I did spray on 2 coats of Rust Encapsulator. There are a few dings in it and I will work on them after I get the underside clean. Esahlin - I will follow the directions you had given in the previous link -Thanks once again for your Help!!!!!
My brother took some measurements of the trunk lids and the middle of the Goodmark Trunk Lid is about 3/16" to narrow compared to the original. I think the original Trunk Lid found its way back on the car after so many years.