Alittle work.
If you find a donor car you will need the factory seat brace that goes from side to side , it is spot welded so you will need a good 3/8" drill bit and basic prying tools to remove it . You will also need the one small square plate that has the seat mounting bolt on it .
Take a note pad and take down all the measurements . Clean it all up and remig it to your car.
I have removed these braces too keep them for others doing this but i don't have any right now or they would be yours . mike.
Check the 73/77 abody section maybe someone has a spare set for you.
__________________
Ban low performance drivers... Not high performance cars.
|