Just a tip with the 3M trim adhesive - Take the seat back out first, dry fit the package tray and mark where the flap on the package tray falls. Spray the 3M adhesive on both the flap and where it will attach to, wait for a couple of minutes so the adhesive starts to set up. Tuck the cardboard under the window and side trim and then pull the flap and hold it in place until it sets up. Replace the seat back. The padding that they sell is too thick and puts too much upward pressure on the package tray. When I did mine I didn't use it and never had any problem with it lifting up.
__________________
More pictures of my former Goat:
http://www.barrett-jackson.com/appli.../w_search.aspx
My old car is listed in the 2007 Scottsdale Auction, Lot #1016 - $60K
And in the 2008 Scottsdale auction, Lot #960 - $80K
Eventually sold by Brighton Motor Sports in Scottsdale, AZ -$89,900
|