[Rack776]

Sorry guys I had a bad weekend changing a fuel pump on my truck
so I did not get to take the scoop photos yet, I'll go out to the garage
this week and take photos and post them,

I had the same problem with the front of my shaker rubbing the hood too hard at the front and sitting too low at the rear. I wore out the rubber seal on the scoop.

I dont know why edelbrock cant get the carb flange machined at the
right angle for a pontiac. The intake I bought in the 1990s was ok,
then I bought one about 2 years ago and the angel was kinda off.

Later, Jason