[screamingchief]

Originally Posted by ponjohn

Can an RPM made to match the 1233?

RPM ports are stated by Edelbrock as being 2.06" x 1.10" .

The RPM ports are ever so slightly bigger than a stock intake port in my experience.

But a quick port match on the heads,and that port size is usually is just about right for the stock RPM intake port size.

For that "basically stock/port matched" port size I use the Mr. Gasket ultra-seal #5848 intake gasket,as that gasket measures 2.06" x 1.14",I use that with the torker II also most times.

But to answer the question,yes the RPM can be port matched to the Fel-pro #1233 intake gasket size.

HTH.