http://www.sdperformance.com/ The rods might be fine resized with ARP rod bolts But I believe its a ticking time bomb on the Squeeze, Good Rods like The Tomahawk forged rods from SD or Eagle H-beams, The TRW are ok but IMO need a Lighter weight pin and use a Good Speed Pro Moly Ring Set, See the lighter the rods/pistons/pins get the Stronger it gets and less stress will be placed on the block, as long as you use decent parts you will be fine, I doubt you will even hit 6000 rpm, Keep compression at 9.5:1 Minumum for 92-93 octane fuel with that cam, a Torquer 2 intake or Performer RPM would be my choice with an 850 Holley Based carb, 1-3/4 Minumum Primary Header, oh And Don't Skimp on the Converter!!! a Continental 3500 stall or Red Neck 3500 would be best for that Cam IMO, Goodluck !
__________________
D.S.R.E. Your NW Pontiac Street/Strip Engine Builder, Specializing in Cylinder Head,Intake Manifold,and Exhaust Manifold Porting services and Building the Most Efficient stock rebuilds to Hi HP Pump Gas and Race Combinations for Pontiac,Buicks,Olds,FE Fords,385 Series and HP Gen 3 and 4 LS engines!
2006 silvy Z71 4X4,383 LS 600+hp NA
Shared Toy-66 Lemans 470cid by me 537hp 580tq-manifolds, 570hp 590tq-2"headers,custom cam,rpm intake, mild e-heads, Looks stock ;-}
|