Baron,
Thanks, I look forward to seeing the pictures.
Quote:
Originally Posted by Baron Von Zeppelin
I'll get some pix taken of it in next day or two and send to your email.
I'm sure you "could" cut your own holes with a hole saw.
Maybe go under sized a little, and finish to correct size with a cylinder/roll sander might be a good way to avoid messing up woodgrain around cut edges.
Ideally, i'd do a test on a crap bezel first.
I sourced this piece a few years ago for a local guy who built a kick azz Formula drag car. He wanted one he could cut his own holes for aftermarket gauges. This one has a lot of blank space for that.
Never ran into him again after i found it, and been too slack to try and locate him.
|