Quote:
Originally Posted by BILTIT
I am trying to stay away from a cell.
I am going to narrow the stock tank ~1.5'' each side, whatever is required.
I will look into the bar across the back, i like the idea of the strength it would add to the rear frame.
|
If I recall correctly (its been a long time since the stock tank was in the car), the tank kicked up toward the bumper. Since your not trying to lower the car you may be able to weld a piece of square tubing to the bottom side of each frame rail and it might clear the tank. Or you could drop the section down to give the needed room around the tank. I'm sure removing the tank would be a pain if you ever needed to. This possibly could allow the sliders if you wanted, set the ride height, tie the rear rails together, while keep the stock tank. Just thinking out loud, lol.
Good Luck with the project.
