Quote:
Originally Posted by Cliff R
If you are building from scratch, you should be looking at 3" main blocks. Easier to obtain, and plenty of good cranks readily available in just about any stroke you would want to set them up with.....Cliff
|
Hmmm . . .
Since I just discovered that my (former) machine shop misinformed me when it told me my 1973 455 block had to go .040 over, and now it turns out I must go .060 over, but I already have .040 over pistons (that I ordered after relying upon my -former- machine shop, groan) . . . .
Can a 400 block go to a 455 .040 over?