Quote:
Originally Posted by Ollie
Yes, 90 ohms has been a GM standard for years. Do You recall how deep Your tank is? did You have to modify the sender for the tank depth? This is a photo of the sender I have, it is about 10 1/2 deep.
|
I think i had to take an inch out of the the unit, and I know I increased the bend a little. I had the sender out this weekend, and it looks like I moved the resistor to work in the bath tub baffle. I do know there was not alot of fab work in making the sender work. Just some tweaking to get it to fit.
When I put it together, I tacked the ring in, and put the sender inplace, and set up the float, and pump location in the baffle, while I still had the great big hole in the top, so I could see what it was doing.
Is that a third gen sender? Mine had a real curve to it foward (opposite of the fuel lines)
Here is a pic i found. I wound up turning the baffle 90 degrees from this. The pump is off in the pic as well, But the pick up is near the front of the tank, near the lowest point, around the same location as the original pick up.
Here is a link for a handy guide I roughly used when I looked into this conversion. The section on tanks is about all i used.
http://www.ultm8z.com/EFI%20swapper%27s%20guide.pdf