[67'7F6'Bird]

I sprayed some of the Aerosol Can 2K (2 component) Epoxy Primer on the Drivers Side rocker panel. This stuff sprayed just like my spray gun, nice fan and no spatter at all. This was the first time I tried it and I am impressed with it, especially for small areas, less cleanup this way. A little pricey though. I will perform the chip test in a few days.

Mounted the VFN Fiberglass rear bumper, the fit looks very good. I did have it on the car before the complete back half was changed. I guess the panels were lined up pretty good.

I also found an original trunk lid and primed it black, to be bolted on by the weekend.

ENGINE UPDATE:

The 455 block is at the machine shop for a freshening up - Hone, Rings and bearings.
Keeping the domed pistons and 11 to 1 for compression.

I received my stainless SI Valves also, to replace my RAIV valves in my 72'7F6'Heads -
I will have the valve springs checked when there at the machine shop too.



Steve