Quote:
Originally Posted by PONTIAC DUDE
400/500hp plus
0-ring the block & heads. Use S.S. 0-rings.
But offset the top & bottom 0-rings .030
Seal the deck and head surface. Run water out the back of the block and rear of the heads.
Use the Flatout copper gaskets with built on sealer.
Race Hard & Have Fun
|
I appreciate these tips. But, money's tight and didn't not intend on tearin' her down to o-ring it. I've haven't had any real sealing issues with my current .110N tune. I could try an additional 150 shot with a second kit and see how she reacts. When this motor was built I was intending on staying below 300. If I can touch off some 8.50's when needed that should get me by for a little while.