So, if you drill out the spot, then what?
To be done in the right spot, I would think the tank would have to be dropped. I doubt you can get a drill in the right spot for the angle .
In case you did not know, the neck had a 1.5 - 2 inch tube for the vent, that was then run up and bent over then came back down.
The originals were rubber then metal, I believe.
I just used a piece of braided steel AN line and did the same. But the vent tube is kinda important, are you going to tap it?
__________________
........I'm just learning as I go.......
|