Thread: DISTRIBUTOR not able to be removed from block
View Single Post
  #1  
Old 06-21-2010, 02:50 AM
Patina Tiger's Avatar
Patina Tiger Patina Tiger is offline
Junior Member
  
Join Date: Jan 2010
Location: Colorado
Posts: 29
Default DISTRIBUTOR not able to be removed from block
Have a 68 400 engine and the distributor is not able to be removed. The gears un-mesh fine but am only able to lift the shank about 1 to 1.5" up before it binds. Cannot rotate the distributor body either at this point. This should just lift up and out. Is there a rubber O ring or oil seal in the way?


Thanks for the insight

Alex

Reply With QuoteReply With Quote