Thanks soupman I should have just posted that pic.
As you can see there's a good offset on the end ports on the old style flanges & one was basically at the gasket.
Anyone need any D-port flanges cheap? I have around 8-10 sets that I wont be using for obvious reasons. If some one had some time on there hands they could just grind away at them.
I hope this illustrates the amount of R&R I put into each piece of each header. Some things have been redesigned many times to get these the way I wanted them in the first place. Rather than just excepting the easiest & quickest way that the header Co could try to pass off as best anyone can do.
soupman,
your evac tubes are installed. The UPS guy did not pick them up on Fri like they were supposed to. They will be shipped Mon even if I have to drive to the UPS dock to send them like I sent all the others.
|