Quote:
Originally Posted by njsteve
The factory manual has the 72 float spec as 1/4" (which, if my math is correct is 4/16").
Lloyd, my question is this: Isn't 5/16" going to be a lower float height which means less gas in the float well?
Once I get your parts here, I check the float spec and update you all.
|
OK Steve - set your float level to 1/4". I'd forgotten that 1/4" was the factory spec for your carb. My bad!
You're gonna love the way it runs with the updated primary calibrations!
By the way - your gaskets went out in Friday's mail, first class.
Keep us informed!