I have not updated this for a while, so I guess its time for some updates. I have sprayed lizard skin in the interior. So far I have used 8 gallons for the interior and underside of the car. It would appear that I will need at least 4 more gallons to compete the trunk and rear quarter panels.
Here is the roof. I had already covered the floor and firewall with plastic before I started taking photos so the roof is it for now.
I repaired the rear trunk channel. The piece that I cut out is much worse than it appears in the picture. It had rusted from the back side.
I have been working the corners of the rear window where the molding goes.
Original dynacorn fit.
New metal installed to make fit better.
And the final work. First covered with "All Metal" and then skimmed with Rage Extreme
The dynacorn quarter is very distorted and wrinkled in the door area so I covered the flaws with "All Metal" and then Rage extreme.
After reworking the quarter panel door jam I decided to fill the indention at the front.
I removed the rust from the pits on the roof. It took several treatments of PJ but finally got all of the rust out. I think I will skim a coat of "All metal" to fill in the pits. I will probably need to skim the entire roof with Rage.
I still have a lot of filler work before I can prime the car.