Still more work on the firewall and installed the brake pedal assembly today. I'll use some 1X1 on top to tie into the upper original firewall to reinforce the bracket.
Almost done closing up the firewall. Got the last piece shaped and set up in place. Just need to finish trim it and weld it in and the firewall will be done. I'm using body seam filler to seal off all the seams. Then I can grind all the welds down and bondo/sand and paint. That will be a good job done.
The little pocket on the drivers side is there for the master cylinder. I'm debating a manual cylinder or finding a hydro-boost unit. But I don't want a power steering pump on the motor so I'll probably go manual. Mark L