Quote:
Originally Posted by Norwood
Formula8, please list the demensions of your nEW PG stripe.
|
I don't know if my stipe is new or not as I purchased it around Novermber of 2010. Anyway, from the outside clear border, my stipe is:
Roof 17 7/8"
Trunk 18 3/8
FWIW, save your money on any glide on fluid or otherwise. I used it on the trunk stripe and it took a good 45 mins to get all of the gel out from under the stripe. I watched several videos on Youtube and the pros use about a teaspoon full of baby shampoo with water in a large spray bottle. Using that, the roof and hood took about 15 mins and came out much better so save the $20.
The border on my stripe was not perfect. I simply used an exacto knife and drywall square while the stipe was on the table and cut it straight. Simple, easy and no hassle.
It is sitting in the sun today to bake out any of the remaining bubbles. Once I dumped the gel, the hardest part was folding the stripe over the rear spoiler where it meeds the trunk lid. I ended up using a heat gun on that and it was all good.
__________________
71 Formula 433, Splayed cap 400 block, 4" stroke Scat forged crank, 6.8 Eagle rods, custom Autotec pistons. SD 295 KRE D ports, Old faithful hybrid roller, Torker II, Holley Sniper Stealth, Tribal Tubes, TKO 600, 3.73 Eaton posi.
|