How sure are you that the problem is in the fender and not the hinge?
I noticed that you don't have the inner fenders in place..Correct?
You may find a whole new set of challenges when you add them into the mix. Quite a bit of flexing neccessary to get all the screw holes lined up between the fenders, the lower cowl, core support and the inner fenders.
PS- I just re-read your previous post and you explained how you know it's the fender. Looking at the picture again, it occurred to me that you might be able to rig up a good, heavy slide hammer to pull that portion of the fender out.
__________________
Greg Reid
Palmetto, Georgia
 
|